Manual operation can be used temporarily in case
you can't find the remote controller or its batteries are
exhausted.
1. Open and lift the front panel up to an angle until it
remains fixed with a clicking sound.
2. Press the button and the Operation lamp lights up,
the unit will operate in "AUTO" mode (the setting
o
temperature is locked on 24 C).
3. Press the button twice to turn off the air conditioner.
Manual operation
Auto/Cool
Manual control
button
Once you push the manual control button, the operation mode is shifted in an order as:
AUTO--COOL--OFF.
Push the manual control button to operate in forced COOL mode, this is used for testing
purposes only. You had better not choose it.
To restore the remote controller operation, use the remote controller directly.
CAUTION:
Adjusting air flow direction
Adjust the air flow direction properly otherwise, it might cause discomfort or
cause uneven room temperatures.
Adjust the horizontal louvre using the remote control.
Adjust the vertical louvre manually.
Adjusting the Vertical Air Flow Direction (up - down)
The air conditioner automatically adjusts the vertical air flow direction in
accordance with the operating mode.
To set the vertical air flow direction
Perform this function while the unit is in operation.
Press the SWING button on the remote control to move the louvre,
and press it again when the louvre gets to the desired direction.
Adjust the vertical air flow direction to the desired direction.
When starting operations, the vertical air flow is automatically set in the
direction written in micro-processor.
To set the horizontal air flow direction (left - right)
Adjust the vertical louvre manually using the lever on the left or right side of
the vertical louvre arm (Depending on model). Take care not to catch fingers
on the fan, horizontal louvre or to damage vertical louvres.
When the air conditioner is in operation and the horizontal louvre is in a
specific position, move the lever at left (or right, depending on model) end of
the air outlet to the desired position.
To automatically swing the air flow direction (up - down)
Perform this function while the air conditioner is in operation.
Keep pressing the SWING button on the remote control for
more than 2 seconds, the horizontal louvres swing automatically.
To stop the function, press the SWING button once again.
7
ADJUST
AUTO
COOL
DRY
HEAT
HEALTH
HIGH
MED
LOW
MODE
FAN SPE
ED
SWING
TIMER ON
SLEEP
ON/OFF
TIMER OFF
AUTO
CLEAN
RESET LOC
K
SET TEM
PERATUR
E( C)
FOLLO
W
ME
LED
DISPLAY
CLEAR
AIR
TURBO
To Next Page
Loading...
Need help?
General
