The SWING buttons will be disabled when the air
conditioner is not in operation.
Do not operate the air conditioner for long periods with the air
flow direction set downward in cooling or dry mode. Otherwise,
condensation may occur on the surface of the horizontal louvre
causing moisture to drop on to the floor or furnishing.
Do not move the horizontal louvre manually. Always use the
SWING button. If you move this louvre manually, it may
malfunction during operation. If the louvre malfunctions, stop
the air conditioner once and restart it.
When the air conditioner is started immediately after it is
stopped, the horizontal louver might not move for approximately
10 seconds.
Open angle of the horizontal louvre should not be set too small,
as Cooling or Heating performance may be impaired due to too
restricted air flow area.
Do not operate unit with horizontal louvre in closed position.
When the air conditioner is connected to power (initial power),
the horizontal louvre may generate a sound for 10 seconds,
this is a normal operation.
CAUTION
!
Range
8
To achieve Optimal performance, please note the following:
Adjust the air flow direction correctly so that it is not directed on people.
Adjust the temperature to achieve the highest comfort level. Do not adjust the unit to
excessive temperature levels.
Close doors and windows on COOL or HEAT modes, otherwise performance may be reduced.
Use Timer ON button on the remote control to select a time you want to start your air
conditioner.
Do not put any object near air inlet or air outlet, as the efficiency of the air conditioner may be
reduced and the air conditioner may stop running.
Clean the air filter periodically, otherwise cooling or heating performance may be reduced.
Do not operate unit with horizontal louvre in closed position.
Optimal operation
To Next Page
Loading...
Need help?
General
