MCAC-RTSM-201301-01 Midea R22 T1 side-discharge duct manual
61
8.2 Introduction of function buttons on the remote controller
Notes:
This illustration is for explanation purposes only. The actual shape or button names of the remote controller may
be slightly different.
① TEMP Button: Push the TEMP button to decrease the indoor temperature setting or to adjust the
TIMER in a counter-clockwise direction.
② MODE Select Button: Each time you push the button, a mode is selected in a sequence that goes
from AUTO, COOL, DRY, HEAT and FAN as the following figure indicates:
③ SWING Button: Push this switch button to change the louver angle.
④ RESET Button: When the RESET button is pushed, all of the current settings are cancelled and
the control will return to the initial settings.
⑤ ECONOMIC RUNNING Button: Push this button to go into the Energy-Saving operation mode.
⑥ LOCK Button: Push this button to lock in all the current settings. To release settings, push again.
⑦ CANCEL Button: Push this button to cancel the TIMER settings.
⑧ TIMER Button: This button is used to preset the time ON (start to operate) and the time OFF (turn
To Next Page
Loading...
