Midea R22 T1 side-discharge duct manual MCAC-RTSM-201301-01
62
off the operation).
⑨ ON/OFF Button: Push this button to start the unit operation. Push the button again to stop the unit
operation.
⑩ FAN SPEED Button: This button is used for setting Fan Speed in the sequence that goes from
AUTO, LOW, MED to HIGH, then back to AUTO.
TEMP Button: Push the button to increase the indoor temperature setting or to adjust the TIMER
in a clockwise direction.
VENT Button: Push this button to set the ventilating mode. The ventilating mode will operate in
the following sequence:
Notes:
Ventilation function is available for the fresh air series.
8.3 Names and functions of indicators on remote controller
①TRANSMISSION Indicator: This indicator lights when remote controller transmits signals to indoor
unit.
② MODE Display: Show the current operation modes-- AUTO, COOL, DRY and HEAT. HEAT is
only available for heat pump model.
③ LOCK display: To displayed by pushing the LOCK button. Push the LOCK button again to clear
To Next Page
Loading...
