Midea R22 T1 side-discharge duct manual MCAC-RTSM-201301-01
66
temperature will re-appear on the digital display.
c. Set the STARTING & STOPPING time
※ Press the CANCEL button to cancel any former settings.
※ Push the TIMER button and the remote controller will show the last set time for START operation
and the signal "h" will be shown on the display panel. You are now ready to readjust the TIMER
ON to start the operation.
※ Push the TEMP button (▲ or ▼) to set the time you want to start the operation.
※ Push the TIMER button and the remote controller will show the last set time for STOP operation
and the signal "h" will be shown on the display panel. You are now ready to reset the time of the
STOP operation.
※ Push the TEMP button (▲ or ▼) to set the time you want to stop the operation.
※ After setting the TIMER there will be a one-half second delay before the remote controller
transmits the signal to the Air Conditioner. Then, after approximately another 2 seconds, the set
temperature will re-appear on the digital display.
Notes:
1. Please reset the TIMER after cancelling the former time settings.
2. The setting time is relative time. That is the time set is based on the delay of the current time.
Warning
1. Be sure there are no barriers between the remote controller and the receiver of indoor unit
otherwise the air conditioner will not work.
2. Keep the Remote Controller away formal liquids.
3. Protect the Remote Controller from high temperatures and exposure to radiation.
4. Keep the indoor receiver out of direct sunlight or the Air Conditioner may malfunction.
5. Keep controller away from EMI (Electro-Magnetic Interference) supplied by other household
appliances.
To Next Page
Loading...
