Midea MV6-i560WV2GN1-E - P2, H5: Suction Pipe Low Pressure Protection

V6-i VRF 50/60Hz
111
Part
6 - Diagnosis and Troubleshooting
2.17 P2, H5: Suction pipe low pressure protection
Digital display output 2.17.1
Description 2.17.2
 Suction pipe low pressure protection. If the system has a 3-phase protector and the 3-phase protector is connected to
the low pressure switch, the system will display P2 protection when initially powered on, and P2 protection will
disappear once the system reaches a steady state.
 All units stop running.
 Error code is only displayed on the unit with the error.
Trigger / recover condition 2.17.3
 Trigger condition:
For P2 protection: Suction pressure ≤ 0.05MPa.
For H5 protection: P2 protection appears three times in 60 minutes.
 Recover condition: Suction pressure ≥ 0.15MPa.
 Reset method:
For P2 protection: Resume automatically.
For H5 protection: Manually restart.
Possible causes 2.17.4
 Outdoor unit stop valves are closed.
 Insufficient refrigerant.
 Low pressure side blockage.
 Poor evaporator heat exchange.
 Main PCB damaged.