Midea MWH-07CM3X1 - Vent and Airflow Direction Control

9
Vent Control
The vent control is located above the control knobs. The operation method is different on different models (see
the following figures).
For maximum cooling efficiency, CLOSE the vent. This will allow internal air circulation.
OPEN the vent to discharge stale air.
Adjust air flow direction
Vertical airflow adjustment
For the units with AUTO SWING feature (automatically)(on some models):
When the AUTO SWING switch is turned to ON position, the vertical louvers
automatically oscillate right and left sweeping the cold air alternately to obtain
comfortable cooling. The vertical louvers may be stopped at any position when the
AUTO SWING switch is turned “OFF”.
For the units without AUTO SWING feature (manually):
To adjust vertical airflow direction, move the lever gently to the left or right by hand
until the desired horizontal airflow direction is obtained.
NOTE: Only For the units with hand-operating lever.
Horizontal air flow adjustment (manually)
To adjust vertical air flow direction of the up or low horizontal louvers, adjust
any one of the up or low horizontal louver blades.
To open the vent, set the lever to the right position.
To close it, set the lever in the left position.
To open the vent, pull the lever toward you
To close it, push it in.