8
THERMOSTAT
The thermostat is used to set the desired room temperature when the unit is being
operated in the COOL MODE.
To set the desired room temperature, rotate the thermostat switch to the desired
setting. The temperature you are setting gets higher from “med” to “min”, lower
from “med” to “max”. After the set temperature is achieved, the thermostat will
automatically start and stop the compressor in order to maintain the desired set
temperature.
NOTE: During the cooling operation of the unit, when the thermostat knob is
rotated clockwise, allow at least three minutes before turning back the knob to the
“min” or “max” direction. Otherwise the fuse may blow due to an overload of the
unit.
SELECTOR
The controls featured in this manual are representative of many available models. Your model may offer
slightly different features.
The desired cool setting is selected by rotating the knob to the right to the appropriate location.
“OFF” will completely shut off the unit.
“HIGH COOL” has maximum cooling effect and airflow.
“MED COOL” has the intermediate cooling effect and airflow.
“LOW COOL” has minimum cooling effect and airflow.
“HIGH FAN” permits high fan speed operation without cooling effect.
“MED FAN” permits med fan speed operation without cooling effect.
“LOW FAN” permits low fan speed operation without cooling effect.
Note: When selecting a fan mode operation, the compressor will not run.
Note: Some models without “MED” speed.
Note
When turning the SELECTOR knob from "LOW COOL" to "HIGH COOL", keep your speed slow as far as
possible. Do not change the operation mode between "LOW COOL" and "HIGH COOL" too often.
To Next Page
Loading...
