7
OPERATING INSTRUCTIONS
Controls
The electronic control keypad will look like one of the following:
NOTE: The outline of the operation panel is based on typical model, the function is the same with your
air conditioner while some difference may exist in appearance.
OPERATING INSTRUCTIONS
THERMOSTAT
The thermostat is used to set the desired room temperature when the unit is being
operated in the COOL MODE.
To set the desired room temperature, rotate the thermostat switch to the desired
setting. After the set temperature is achieved the thermostat will automatically
start and stop the compressor in order to maintain the desired set temperature.
Rotate the thermostat selector clockwise for higher cool settings. Higher cool
settings will provide lower room temperature. Rotate the thermostat selector
counter clockwise for lower cool settings. Lower cool settings will provide higher
room temperature.
NOTE:
Test is used to test the compressor and make sure the unit is working properly.
Do not use this position for regular operation.
During the cooling operation of the unit, when the thermostat knob is rotated
clockwise, allow at least three minutes before turning back the knob to the “min”
direction.
Otherwise the fuse may blow due to an overload of the unit.
DO NOT rotate the THERMOSTAT knob beyond the range from “min” to “max”.
To Next Page
Loading...
