15
Step 3. Installation.
1. Remove the screws fix the chassis-fixing board and cabinet. Some Models have two more screws on the
back of the cabinet. (See Fig.5)
2. Grasp the handle on the chassis and carefully slide the air conditioner out of the cabinet. (See Fig.6)
3. When need to drain off water, install the drain plug on the Chassis board. Then fix the cabinet on the
supporter (provide for yourself or contact the dealer)(see Fig.7).
4. Push the unit chassis into the cabinet. (See Fig.8)
5. Fix the chassis and cabinet. (See Fig.5)
Step 4. Install the frame.
1. Install the frame and connect the coupler plugs, making sure not to interfere with the temperature
sensor cable (See Fig.9).
2. Fix the screws on the frame (See Fig.3A, 3B, 3C, 3D).
Step 5. Install the air filter and front panel.
1. Install the air filter into the frame's slot from upside to underside (See Fig.2).
2. Hang the front panel on the frame's buckle, then press the front panel into the frame's slot until
you hear a click (See Fig10).
Installation Steps Option: Power Cord Come Out from Left Side
Step 1. Install the power cord
1. Pull the power cord to the left side
straightly (See Fig.1C 2C.).
2. Wrap the PVC protecting sheath on the
power cord with ribbing in the hole position
(See Fig.3C).
Step 2. Tie up the power cord on the frame
(Just for the body dimension 600*380*560)
1. Tie up the power cord on the frame (See
Fig.5C 6C.).
Step 3. Install the frame the front panel
1. These steps is same as right side. (See
Fig.4C.).
To Next Page
Loading...
