17
CLEANING AND MAINTENANCE
IMPORTANT:
• Always unplug the power cord from the power socket
and allow the appliance to cool down before cleaning or
maintaining it.
• Never immerse the appliance in water or any other liquid.
• Never use abrasive cleaning products on this appliance
(alcohol, solvent).
Basic cleaning
1. Use a slightly damp cloth to wipe the outside of the heater to remove dust and dirt.
2. Use a vacuum cleaner to remove dust from ventilation holes.
3. Make sure the heater is dry before unplugging it.
Thorough cleaning
1. Gently pull the release latches at the bottom of the air intake grille on the back
of the appliance, then remove the grille.
2. Pull out the black filter behind the grille.
3. Soak the filter in clean, clear water for a few minutes, then dry it thoroughly.
4. Clean the filter compartment with a soft, dry cloth.
5. Put the dry filter back behind the grille.
6. Put the air intake grille back on the appliance until it clicks into place.
If the appliance is not going to be used for an extended period
If you do not plan to use the appliance for an extended period:
1. Turn off and unplug the appliance.
2. Clean the appliance as described in the section above.
3. Remove the batteries from the remote control and store them with the appliance
in a clean, dry place.
To Next Page
Loading...
