9 10
Cleaning the Grille, Case and Remote Control
A cloth dampened with cold water may be used
on the indoor unit if it is very dirty. Then wipe it
dry with a dry cloth.
Do not use a chemically treated cloth or duster to
clean the unit.
Do not use benzine, thinner, polishing powder, or
other similar solvents for cleaning. These may
cause the plastic surface to crack or deform.
WARNING! Never use water hotter than
O O
40 C/104 F to clean the front panel, it could cause
deformation or discoloration.
CAUTION
CARE AND MAINTENANCE
Care and Maintenance
Turn the system off before cleaning. To clean, wipe with
a soft, dry cloth. Do not use bleach or abrasives.
NOTE: Power supply must be disconnected before
cleaning the indoor unit.
Filter Handle
Cleaning the Air Filters
Clogged air filters reduce the cooling and heating
efficiencies of this air conditioning unit. PLEASE
CLEAN THE AIR FILTERS ONCE EVERY 2 WEEKS.
1. Lift the indoor unit panel up to an angle until it
stops with a clicking sound.
2. Take hold of the handle of the AIR FILTER and lift it
up slightly to take it out from the filter holder, then
pull it downwards.
3. Remove the AIR FILTERS from the indoor unit.
Clean the AIR FILTERS once every two weeks.
Clean the AIR FILTERS with a vacuum cleaner or
rinse with water, then dry them off in a cool place
before putting them back in the filter holder.
OPERATING INSTRUCTIONS
NOTE: Power supply must be disconnectd before
cleaning the indoor unit.
Front Panel and Louver Closing Properly
Front Panel and Louver Closing Improperly
Preparation Before Care and Maintenance
How the Air Conditioner Works
1 hour
1 hour
Set
Temperature
Set
Temperature
Cooling
Heating
SLEEP operation
1 hour
1 hour
SLEEP operation
7 hours timer off
7 hours timer off
AUTO Operation
When you set the air conditioner in AUTO mode, it will
automatically select COOLING, HEATING (for cooling
and heating models only), or FAN ONLY operation
depending on set temperature and room temperature.
The air conditioner will control room temperature
automatically to the temperature point you set.
If you feel uncomfortable in the AUTO mode, you can
select your desired temperature.
SLEEP Operation
When you push SLEEP button on remote control during
COOLING, HEATING (for cooling and heating models
only), or AUTO operation, the air conditioner will
automatically increase (in COOLING) or decrease (in
HEATING) 1 C/2 F per hour for the first 2 hours, then
O O
hold steadily for the next 5 hours, after that it will turn off.
This mode saves you energy and brings comfort at night.
DRYING Operation
The fan speed will be automatically controlled under
DRYING operation.
During the DRYING operation, if the room temperature is
O O
lower than 10 C(50 F), the compressor stops operation
and restarts when the room temperature is above
O O
12 C(54 F).
Optimal Operation
To achieve optimal performance, please note the
following:
Adjust the airflow direction correctly so that it does not
blow directly at people.
Adjust the temperature to achieve the most comfortable
level. Do not adjust the unit to excessive temperature
levels.
Close doors and windows on COOL or HEAT modes,
otherwise performance will be reduced.
Use TIMER ON button on the remote control to select a
time you want to start your air conditioner.
Do not put any object near air inlet or air outlet, as the
efficiency of the air conditioner may be reduced and
the air conditioner may stop running.
Clean the air filter every 2 weeks, otherwise cooling or
heating performance may be reduced.
Do not operate unit with horizontal louver in closed
position.
The unit must be correctly sized to condition the room.
To Next Page
Loading...
