What to do if my Midea Heat Pump is leaking water?
If your Midea Heat Pump is leaking water, it's likely due to hydraulic pipeline joints not being sealed properly. The solution is to carefully check and reseal all the joints in the hydraulic pipeline.
Why is there no hot water coming from my Midea RSJ-15?
If there is no hot water coming from your Midea Heat Pump, it could be due to several reasons: * The public water supply might have ceased; wait for it to recover. * The cold water inlet pressure might be too low (less than 0.15 Mpa); wait for the inlet water pressure to increase. * The cold water inlet valve might be closed; open the water inlet valve.
What to do if the Midea RSJ-15 Heat Pump display is off and the water is cold?
If the display screen of your Midea Heat Pump is off and you're getting cold water, there could be a few reasons: 1. There might be a bad connection between the power supply plug and the socket. Ensure it is properly plugged in. 2. The water temperature setting might be too low. Try setting the water temperature higher. 3. The temperature sensor or the PCB of the indicator might be broken, or the compressor might be broken. In this case, contact a service center.
Crucial safety warnings regarding earthing, RCD, and professional installation.
Details on electrical connections, wiring, and a comprehensive checklist for installation completion.
Guidance on responding to errors and a table of common issues, causes, and solutions.
Detailed table of error codes, malfunction descriptions, and corrective actions.
To Next Page
General