To Next PageTo Next PageWhat to do if my Midea Heat Pump system shows an error?
If your Midea Heat Pump system is showing an error, try resetting the system. After resetting, check to see if the error reappears. This can help identify if it's a recurring issue.
What to do if my Midea Heat Pump has an electric leakage error?
If you encounter an electric leakage error with your Midea Heat Pump, inspect the PCB (Printed Circuit Board). Check for any potential short circuits that may be causing the leakage.
What to do if my Midea RSJ-15/190RDN3-D shows (T4) Outdoor ambient temperature sensor error?
If your Midea Heat Pump displays a (T4) Outdoor ambient temperature sensor error, switch to Enhanced Heating Mode. This may help to resolve the issue.
What to do if my Midea RSJ-15/190RDN3-D Heat Pump shows (T3) Condenser output pipe temperature sensor error?
If your Midea Heat Pump is showing a (T3) Condenser output pipe temperature sensor error, test the sensor. If the sensor is faulty, replace it.
What to do if my Midea RSJ-15/190RDN3-D shows Tank and Wired Controller communication error?
If your Midea Heat Pump displays a Tank and Wired Controller communication error, inspect the wiring. Look for any loose connections or damages that might be causing the communication problem.
General| Type | Heat Pump |
|---|---|
| Heating capacity | 5.27 kW |
| Cooling capacity | 4.4 kW |
| Refrigerant | R410A |
| Power supply | 220-240V, 50Hz |
