MCAC-HTSM-201506 Midea R410A Direct Heating Commercial Heat Pump 50Hz Technical Manual
66
1.3.2 Setting operating modes and parameters
Press SET key to enter the operation mode and parameters setting. The setting
contents will change as the following order each time the key is pressed.
The setting options in the dotted line frame are not general setting. The wired controller
automatically judges the needed setting according to the model of main unit.
Setting water temperature
Press the ▲ or ▼ button to adjust the water temperature after the controller is
powered on. Or press SET key once when ‘SET WATER TEMP’ is displayed on
the LCD and then press the ▲ or ▼ button to adjust water temperature.
To check water temperature setting, press or key under the main page (the
page displayed after the controller is powered on).
To Next Page
Loading...
