Midea SV 8.45 wi - Page 65

8

Followthestepsbelowtoadddishwashersalt:






1.  Removethelowerbasketandunscrewthecontainercap.
2.  Fillthe salt containerwith water to themaximum.Itisnormalfora small
amountofwatertoescapefromthesaltcontainer.
3.  Inserttheendofthefunnel(supplied)intotheholeandaddabout
0.8kgofdishwashersalt.
4.  Screwthecapbackonafterfillingthecontainer.
5.  Thesaltwarninglightturnoffoncethesaltcontainerhasbeenfilledwith 
salt.
6.  Immediatelyafterfillingthesaltintothesaltcontainer,awashprogram
shouldbestarted(werecommendashortprogram).Otherwise,the
filtersystem,pumporotherimportantpartsoftheappliancemaybe
damagedbythesaltwater.Thisisnotcoveredbythewarranty
.



NOTE:
•  Thesaltcontainermayonlyberefilledifthesaltwarninglight( )in
the operating panel is illuminated. Depending on how well the salt
dissolves, the salt warning light may remain on even if the salt
containerisfull.
Ifthereisnosaltwarninglightontheoperatingpanel(onsomemodels),
you can estimate when to refill the salt in the softener based on the
numberofwashcyclesthedishwasherhasrun.
•  Ifsaltisspilled,runasoakorquickprogramtoremoveit.