EasyManuals Logo

Midea Vertu series User Manual

Midea Vertu series
54 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #47 background imageLoading...
Page #47 background image
45
8.4.9 Auto-Restart function
The indoor unit is equipped with auto-restart function, which is carried out through an auto-restart
module. In case of a sudden power failure, the module memorizes the setting conditions before the
power failure. The unit will resume the previous operation setting (not including Swing function)
automatically after 3 minutes when power returns.
If the memorization condition is forced cooling mode, the unit will run in cooling mode for 30 minutes
and turn to auto mode as 24 setting temp.
If A/C is off before power off and A/C is required to start up now, the compressor will have 1 minutes
delay when power on. Other conditions, the compressor will have 3 minutes delay when restarts.
8.4.10 Automatic panel function
8.4.10.1 The automatic panel is forced to turn to the closing direction at an angle of 50°when the unit
is getting through the power, and this action is not affected by any signal from remote controller.
8.4.10.2 When the unit is turned on, the panel is opened automatically at an angle of 50°, then the
horizontal louver will be opened.
8.4.10.3 When the unit is turned off, the panel is closed automatically at an angle of 50°, then the
horizontal louver will be closed.
8.4.10.4 If the panel needs moving when the horizontal louver is in action, the unit will stop the
horizontal louver and then carry out the action of the panel. After ending the action of the panel, the
horizontal louver will continue its action.
8.4.11 Ionizer (Clean Air) function
8.4.11.1 Clean Air function is available only when the A/C is on, and it’s controlled through remote
controller.
8.4.11.2 After the A/C being turned on, the Clean Air function is switched on when the A/C receives
FRESH CODE at first time, and ionizer is switched off when the A/C receives the CODE again. It’s a
circle.
8.4.11.3 After starting the Clean Air function, the ionizer can work only when the indoor fan motor is
running. If the indoor fan motor is off, the ionizer also stops working, even though the Clean Air
function is available.
8.4.11.4 Switching the running mode will not stop the ionizer. When turning off the A/C, the ionizer is

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Midea Vertu series and is the answer not in the manual?

Midea Vertu series Specifications

General IconGeneral
BrandMidea
ModelVertu series
CategoryAir Conditioner
LanguageEnglish

Related product manuals