MIDI MODE
Press FUNCTION button, the display will show “F-“ to prompt you to input a function code.
Then press M.MODE button, current MIDI mode code will appear on the display. Now, you
can change MIDI mode by numerical button 1 - 4 or + / - button to change it.
- Omni On, Poly
- Omni On, Mono
- Omni Off, Poly
- Omni Off, Mono
About 3 seconds after you complete the operation, the display will return to indicate program
number.
RESET ALL CONTROLLER
Press FUNCTION button, the display will show “F-“ to prompt you to input a function code.
Then press C.RST button, “ALL” will appear on the display and message of reset all
controllers will be sent out immediately.
About 3 seconds later after you complete the operation, the display will return to indicate
program number.
To Next Page
Loading...
