Midland A-22075 Series - Page 35

P/N: A-22075/6, Rev. 1.1
Page 35 of 45
CAUTION: Stem-Thread Damage. Since all nickel-bearing stainless steels have a
likelihood of galling, wrenching the adjusting nut without relieving the spring’s load
will frequently result in damaged stem threads.
8.1.5 Apply indicator (reference) marks to the bottom spring-adjusting nut and the spring follower, and
then loosen or tighten the spring-adjusting nut two turns.
Figure 8-5 Spring-Adjusting Nut
8.1.6 Release the spring compressor.
Figure 8-6 Release Spring Compressor
CAUTION
Spring-Adjusting Nut
Spring Follower