ENGLISH
TECHNICAL SPECIFICATIONS
GENERAL
Channels ................................................................40 FM (see the frequency band chart)
Frequency Range ...........................................................................26.565-27.60125 MHz
Frequency Control ........................................................................................................PLL
Operating Temperature Range ..........................................................................-10°/+55° C
DC input voltage ........................................................................................13.8V DC ±15%
Size ........................................................................................180 (L)x50 (H)x150 (P) mm
Weight............................................................................................................................1kg
RECEIVER
Receiving system ............................................................dual conversion superheterodyne
Intermediate frequency ................................................I° IF: 10.695 MHz • II° IF: 455 KHz
Sensitivity....................................................................0.5µV for 20 dB SINAD in FM mode
..................................................................................0.5µV for 20 dB SINAD in AM mode
Audio output power @10% THD ................................................................2.0 W @ 8 Ohm
Audio distortion................................................................................less than 8% @ 1 KHz
Image rejection ..........................................................................................................65 dB
Adjacent channel rejection..........................................................................................65 dB
Signal/Noise ratio ......................................................................................................45 dB
Current drain at stand/by..........................................................................................250mA
TRANSMITTER
Output power....................................................................duty cycle 10% 4W @ 13.8V DC
Modulation ......................................................................................AM: from 85% to 95%
..........................................................................................................FM:1,8 KHz ± 0,2 KHz
Frequency response ......................................................................from 400 Hz to 2.5 KHz
Output impedance ..........................................................................RF 50 Ohm unbalanced
Signal/Noise Ratio ..............................................................................................40 dB MIN
Current drain ..............................................1100mA (Power position with no modulation)
All specifications are subject to change without notice.
7
To Next Page
Loading...
