Midland BT1 User Manual

14
LIGHT AND SOUND SIGNALS
LED indication Status
GENERAL
None Unit is switched off or full charged when connected to the power supply
Single Blue ash every 3 seconds Unit being turned on/ Unit in working mode
Triple red ash Unit being turned off
Single Blue ash every 3 seconds
Single Red ash every 3 seconds
Standby
Standby - low battery
RED and BLUE (together) every 3
seconds
Active (Intercom, phone call or Bluetooth connection in progress)
RED and BLUE (together) and one ash
of RED light every 3 seconds
Active but low battery
Single red ash every 2 seconds Unit in charge when connected to the power supply
SETUP
Steady Red Setup mode
Rapid Red-Blue alternating ash Pairing mode (searching for devices)
Steady Blue for two second Successful pairing/ Reset paired devices/Three way enabled/ Intercom always open
enabled
Blue light two time long ash Three way disabled/ Intercom always open disabled
Audio signals
Status
Ascending tone (low-high) Unit being turned on
Descending tone (high-low) Unit being turned off
Enable/Disable the Intercom 1 tone = enabled / 2 tones = disabled
1 tone Specic feature turned on
2 tones Specic feature turned off
UNIT FUNCTIONS
If you want to... …do this
GENERAL
Turn on the unit Press the Intercom button for 3 seconds at least (start Blue ash)
Turn off the unit Press the Intercom and AUX button together for 3 seconds (triple Red ash)
Increase the volume Short or continues press on the Volume Up control
Decrease the volume Short or continues press on the Volume Down control
MOBILE PHONE (only driver’s unit)
Answer a call Short press of the Phone button / say a word
Reject a call Long press the Phone Button / remain silent until the rings stop
Terminate a call Short press the Phone Button

Midland BT1 Specifications

General

Brand	Midland
Model	BT1
Category	Intercom System
Language	English