Midland M Zero - Replacing Fuse; Connecting the Microphone

6 | M Zero Instruction Guide
=+*
7( ,?;
(5;
/05& *G XJSJOH EJSFDUMZ UP WFIJDMF DJSDVJU DVU PGG UIF MJHIUFS QMVH BOE JOTUBMM BO
JOMJOFGVTFGPMEFSBOE".1GVTF
Mount in position with bolts, lock washers and nuts or self-
threading screws. 5IJT transceiver DBO CF JOTUBMMFE in any location
where 126V%$ ± 10% power is available. Insert the power cable with
lighter plug into the vehicle’s cigarette lighter cord. %POPUQPXFSPO
UIFSBEJPVOUJMUIFantenna systemIBTCFFODPOOFDUFE. The lead from
the antenna should be connected to the 40 antenna connector. If
using an external speaker, connect it to the EXT-SPKR jack.
REPLACING FUSE
If replacJOH the DC Power Cord GVTF, use B 2A.1 type. Hold the
fuse holder and press on the inside, then rotate the holder.
CONNECTING THE MICROPHONE
Your transceiver has a 1*/ microphone connector. This ensures that
you won’t accidentally pull out or loosen the plug connection when
VTJOH the microphone.