Midland MXMC01 - Selecting the Active Channel; Transmitting and Receiving a Call

Page 6
midlandusa.com
Model MXMC01
Selecting the Active Channel
IMPORTANT! To communicate between two radios, both radios
must be set to the same channel (see Selecting a Privacy Code)
selections.
To Select the Active channel
1. Be sure the radio is turned on (See Power On/Off)
2. Press and release the Channel Up button on the microphone to
scroll forward through the available channels. Press and release
the Channel Down button on the microphone to scroll backward
through the available channels.
• The Channel icon on the LCD display will show the active channel.
• To make the repeater channels selectable,
see Activate Repeater Channel.
Setting Volume
1. Turn the Volume knob clockwise to increase the volume.
2. Turn the Volume knob counter clockwise to decrease the volume.
Transmitting and Receiving a Call
IMPORTANT! To communicate between two radios, both radios
must be set to the same channel (see Selecting a Privacy Code)
selections.
To Transmit and Receive a Call
1. Be sure the radio is turned on (see Power On/Off)
2. To transmit a call, press and hold the PTT button on the
microphone and speak into the microphone in a normal voice.
NOTE: For maximum clarity, hold the microphone 2 to 3 inches from
your mouth when speaking.
• The TX icon will show continuously on the LCD display while
transmitting.
3. To receive a call, release the PTT button on the microphone.
• The RX icon will show on the LCD display when your radio is
receiving a transmission.
4. If necessary, turn the volume knob clockwise or counter clockwise
to increase or decrease the radio volume.