Midland WR 120 - Page 2

Your quick start programming is complete. To continue programming other features, continue
with the remaining set-up steps.
ALERT TYPE
Press MENU
Press UP or DOWN arrow until ALERT TYPE is displayed. Press SELECT.
Press UP arrow to select VOICE, TONE or DISPLAY.
TONE - Alert tones will sound for five minutes or until you press any button to stop the tones. If
you press the WEATHER/SNOOZE button, you will hear the voice of the weather broadcast.
VOICE - Alert tones will sound for about eight seconds, then you will hear the voice of the
weather broadcast for about three minutes. If you want to listen longer, press the WEATHER/
SNOOZE button.
DISPLAY - Message scrolls across display. No alert sounds will be heard.
Press SELECT to set alert type.
ALERT TEST
Press UP or DOWN arrow until ALERT TEST is displayed. (This is to test the alarm tone).
Press SELECT - The alarm sounds. Press any button to silence the siren or press MENU to exit
menu mode. Note: make sure that the ON/OFF switch on the right side of the radio is in the ON
position.
Note: This ALERT TEST will only sound the siren. You are not able to hear the VOICE feature or
see the DISPLAY feature with this test.
SET ALARM CLOCK
Press UP or DOWN arrow until SET ALARM is displayed.
Press SELECT.
Press the UP arrow to display ON. Press SELECT.
Press UP or DOWN arrow until the hour you want is displayed.
Press RIGHT arrow to save alarm hour and advance to alarm minutes. Program both minute
digits the same way.
Press SELECT to save the alarm time.
(To temporarily silence the sleep alarm, press the WEATHER/SNOOZE button. The alarm time
will advance by 8 minutes. To silence the alarm for the remainder of the day, press the MENU
button.)
BACKLIGHT
Press UP or DOWN arrow until BACKLIGHT is displayed.
Press SELECT.
Press the UP arrow to choose BLT NORM, BLT ON, BLT OFF, then press SELECT.
Note: BLT NORM turns on a backlight whenever any button is pressed and will turn off after 5
seconds; BLT ON means the backlight comes on and will stay on continuously until you turn it
off manually through the menu; BLT OFF means there is no backlight until it is turned on
manually through the menu.
BUTTON BEEPS
Press UP or DOWN arrow until BUTTON BEEPS is displayed.