Model T50 Series
.J:t:d
_
~~
---------------
~.-IDLAND®
'
CHARGING
THE
BATTERIES
Your radios are equipped for using a rechargeable NiMH battery pack
(BATT3R) which can be recharged by inserting one end
of
the USB
Cable into a USB power source, and the other end into the radio USB
charging jack, or with the optional desktop charger (as described
below). While charging, the Battery Meter will flash from 1 to
3.
bars.
The
LCD
display will show FULL when charging is complete. For
maximum battery life, Midland recommends charging the battery
pack when the low battery icon comes on. Remove the radios from
the charger when the charging is finished.
To
charge using the Desktop Charger:
1.
Place the BATT3R rechargeable battery packs
in
the radios.
2.
Connect one end of the USB Cable into a USB power source.
3.
Insert the other end of the USB Cable into the desktop charger
USB jack.
4. Place the radios into the desktop charger slot. While charging, the
Battery Meter will flash from 1 to 3 bars, and stop when charging
is
finished. The LCD display will show FULL.
In order to ensure
that
the battery pack
is
fully charged,
it
is
recommended
that
the battery pack be charged with the radio
turned
OFF.
1.
Only use the Midland NiMH battery pack.
'
2.
Do
not attempt to charge alkaline batteries or any batteries
or battery packs other than the one indicated
in
the
manual. This may cause leakage and damage to the radio.
•
3.
For long term storage
of
the radio, turn the radio OFF and
remove the batteries from the radio.
BATTERY
LEVEL
INDICATOR
Your radio has a BATTERY LEVEL
METER:---~
that shows the
battery power level. The greater the number of bars visible, the
stronger the battery level. When the battery level is low, the
Battery
Shell:
~
icon and "bt
Lo"
will flash
in
the display indicating your
batteries should
be
replaced or recharged if using a rechargeable
battery pack.
Page 6 midlandusa.com
To Next Page
Loading...
Need help?
General
