Operation
56
Drying assistance
The additional "Drying assistance" function accelerates the drying
process at the end of the program.
If drying assistance has been activated, the door will automatically
open a few centimetres at the end of the program to release steam
from the cabinet. The load will then be dried using passive heat given
off by the residual heat in the cabinet.
The drying function can be pre-selected for all programs with a drying
phase or can be retrospectively switched on or off every time a
program is selected (see "Settings / Drying").
The drying function is switched on or off by pressing the button
before starting the program. The LED in the button will indicate
whether the additional function is switched on or off. The program
drying duration can also be altered.
When the drying function is activated, the program duration will be
longer. However, the drying duration is not calculated in the program
time left shown in the display. It will be displayed during the drying
phase only.
Activating and
deactivating drying
Select a program.
Press the button before the program start. The LED in the button
will indicate whether the drying function is switched on or off.
To Next Page
