Additional settings
85
Ethernet
– Status
Connection status displayed (Active/Inactive)
– DHCP
The Ethernet interface can either be implemented via a Dynamic
Host Configuration Protocol (DHCP) or by setting the following
parameters:
– IP address
– Subnet mask
– Standard gateway
– DNS Server - automatic
– DNS Server 1
– DNS Server 2
– Port type
– Port
RS -232
– Print reports
Subsequent selection of cycle reports (see "Process
documentation").
– Status
Connection status displayed (On/Off)
– Language
Any one of the following languages can be set for the RS232
interface:
– German
– English
– French
– Italian
– Spanish
– Interface function
Using the interface for process documentation.
To Next Page
