3. Selecting an economy interim
rinse (only for "Rapid" program)
^
Turn the program selector to "STOP".
^
Turn the machine off.
^
Press and hold the "Display" and
"Start" buttons, at the same time turn
the machine on with the "On / Off"
button.
The display shows the current
program status "P...".
The "Fill/Drain" indicator lights.
^
Press the "Extra Drying" button once.
"E01" (programming level 1) is
displayed.
^ Turn the program selector to "Rinse".
"40" or "41" is displayed.
"40" = without economy interim rinse
"41" = with economy interim rinse
^ Press "Display" to change from "40" to
"41" or vice versa.
^ Press the "Start" button. "SP" is
displayed.
^
Press the "Start" button again. The
change has been saved.
Value set:
4. Venting and setting the dosage on
"DOS modules G 60 and C 60"
(optional extra)
^
Set the dosage selector on the
DOS-Module to the "10" position (on
DOS Module C 60 only).
^
Turn the program selector to "STOP".
^
Turn the machine off.
^
Press and hold the "Display" and
"Start" buttons, at the same time turn
the machine on with the "On / Off"
button.
The display shows the current
program status "P...".
The "Fill/Drain" indicator lights.
^ Press "Extra Drying" twice. "E02"
(programming level 2) is displayed.
Venting the dispensing system:
^ Turn the program selector to "Rinse".
"do1" is displayed.
^ Press "Display" for 90 secs.
The dosage system is vented.
If only venting is required:
^
Turn the machine off with On / Off
(I-0) button.
Immediately: Start the "Rinse" program,
so that after venting any agents in the
wash cabinet are diluted before being
drained away.
Programming special functions
30
To Next Page
Loading...
