^
Press the foot pedal and "iron" the
new cloth around.
Do not let the cords get under the
cloth as it turns.
After the roller has gone through three
or four revolutions and the end of the
ironing cover is under the heater plate:
^ Turn the rotary iron off while keeping
the foot pedal pressed down.
The ironing cover is held firmly in place
with the heater plate which is still
lowered.
^
Tighten the cords at the left and right
hand sides of the roller, tie together
and tuck in.
^ Put the feed board back in place.
^ Turn the rotary iron on - the heater
plate will rise.
Cleaning and Care
27
To Next Page
Loading...
