Miele CM7500 - Please Note before and During Automatic Descaling; Set the Start Time

Automatic descaling
79
Please note before and during
automatic descaling:
The coffee machine must be ready for
use at the start time, that is, shortly
before the pipework is filled with the
descaling solution. This means:
– The coffee machine is connected to
the electrical supply. The master
switch is in the "I" position.
– The drip tray, brew unit and central
spout are inserted.
– The water container is inserted and is
filled with water at least up to the
descaling mark.
– Carry out the instructions which
appear in the display before
switching off, e.g. Empty the drip tray
or Fill and refit the water container.
– If you have made drinks with milk,
the milk pipework must be pushed
into the drip tray and when the
machine is switched off, the message
about this in the display must be
confirmed with OK.
– At the set start time the coffee
machine pipework will be filled with
descaling solution (this takes approx.
1 minute). Do not disconnect the
coffee machine from the electrical
supply during this time.
When the pipework has been filled with
descaling solution you can remove
parts of the appliance or disconnect it
from the electrical supply.
Set the start time
You can set the daily start time for
automatic descaling as you wish. The
coffee machine must be switched off
for the duration of the activation phase
(approx. four hours). For this reason it is
best to set an evening start time.
Start in the Drinks menu.
 Touch.
 Select Settings  and then Descaling.
 Select Start time.
 Set the start time you want and
touchOK.
The start time is saved. From now on
automatic descaling will commence at
the desired time each day.