Miele CS 1018 G

Conversion to another type of gas
55
To change the jet for the inner burner
d
Jet (main jet for the inner burner)
e
Air intake sleeve
f
Vent
 Remove the screw from the
fitting with an SW8 spanner while
counterholding it with an SW12
spanner.
 Remove the screw fitting from the
part with an SW12 spanner while
counterholding it with an SW12
spanner.
 Remove the jet and replace it with
the new jet (see "Jet table").
 Set the two vents to a distance of
2mm by sliding the air intake
sleeve.
 Screw all parts back on in reverse
order and check for leak tightness.