General
Fit the wall units and extractor hood
before fitting the appliance to avoid
damaging the appliance.
~
The veneer or laminate coatings of
worktops (or adjacent kitchen units)
must be treated with 100 °C
heat-resistant adhesive which will not
dissolve or distort.
Any backmoulds must be of
heat-resistant material.
~
A risk assessment of the installation
must be carried out by a suitably
qualified engineer before this appliance
is installed or used. Installation must
only be carried out by a suitably
qualified engineer.
~
The appliance must be fixed in
position when it is installed. Failure to
do this could result in damage to the
appliance, personal injury and damage
to property.
~
The hob may only be built in over a
Miele oven if the worktop is at least 40
mm thick.
~
Observe carefully the safety
distances given on the following pages.
~
After installing the hob, ensure that
the connection cable cannot come into
contact with the underside of the
appliance. Make sure that there is no
mechanical obstruction, such as a
drawer, which could damage it.
~
This appliance must not be installed
over a dishwasher, washing machine,
tumble dryer, refrigerator or freezer.
The high temperatures radiated by the
hob could damage the appliance
below.
~
All dimensions in this instruction booklet
are given in mm.
Safety instructions for installation
26
To Next Page
Loading...
Need help?
General
