,
Installation work and repairs to
electrical appliances must only be
carried out by a suitably qualified
and competent person in strict
accordance with current local and
national safety regulations. Repairs
and other work by unqualified
persons could be dangerous. The
manufacturer cannot be held liable
for unauthorised work.
Ensure that current is not supplied
to the appliance until after
maintenance or repair work has
been carried out.
Please note: A call-out charge will be
applied for unnecessary service visits
where the problem could have been
rectified as described in these
operating instructions.
What to do if ...
... the cooking zones do not heat up.
Check whether the mains fuse has
tripped. If it has, reset or replace the
fuse.
If this doesn't remedy the problem, turn
the control to "0", and disconnect the
appliance from the electricity supply for
approx. 1 minute.
If it still will not switch on, contact a
qualified electrician or Miele.
... ß flashes in the display for a
cooking zone.
Check whether
–
the zone was switched on by mistake
without a pan on it.
–
the pan being used is suitable for
use on an induction zone, and that it
is large enough (see "Pans").
... C and a power setting flash
alternately in the display.
The power setting has been reduced
because the Booster was switched on
with the connected cooking zone (see
"Booster function").
... C and 0 flash alternately in the
display for a cooking zone.
The cooking zone has switched off
because
–
TwinBooster setting 2 was switched
on with the connected cooking zone
(see "Booster function").
–
There is no pan or an unsuitable pan
on the cooking zone.
–
The overheating protection
mechanism has been triggered (see
section "Overheating protection").
Problem solving guide
28
To Next Page
Loading...
Need help?
General
