Miele CVA 5060 Operating Instructions

Pre-warming cups
The cups should always be pre-warmed to allow the flavour
to develop and be retained. The aroma of espresso does not
react well to cold.
The smaller the volume of coffee/espresso, the more
important it is to pre-warm the cup. Use a plate warming
drawer if you have one. If not, you can warm them as follows:
^
Place the cup to be warmed under the hot water spout.
^
Touch the Hot water sensor.
^
Run a little hot water into the cup to warm it.
^
Touch the OK sensor to stop the flow of water.
^
Leave the cup for about a minute until it is warm, then pour
the water away.
Adjusting the height of the central spout
You can adjust the height of the central spout to suit the
height of the cup so that the drink will not cool down as
quickly as it would if the spouts were further away from the
cup. The crema will also be a better quality if the coffee does
not have so far to go!
^
Slowly pull the central spout downwards.
Making drinks
22

Miele CVA 5060 Specifications

General

Type	Coffee/Espresso
Product type	Espresso machine
Capacity in cups	15 cups
Coffee input type	Coffee beans
Coffee maker type	Fully-auto
Appliance placement	Built-in
Water tank capacity	2.3 L
Coffee beans capacity	500 g
Adjustable coffee strength	Yes
Maximum operating pressure	15 bar
Cord length	3 m
Product color	Black, Stainless steel
Housing material	-
AC input voltage	220–240 V
AC input frequency	50 - 60 Hz

Weight and Dimensions

Depth	480 mm
Width	595 mm
Height	455.5 mm
Installation compartment depth	500 mm
Installation compartment width	560 mm
Installation compartment height	450 mm