Problem solving guide
100
Insert the holder and silicone seal
until they audibly click into place.
Connect together the angular
moulded hose and longer milk pipe.
Start by attaching the top of the
moulded hose to the central spout.
The black connecting piece should
be pointing to the rear.
Then, connect the bottom end of the
moulded hose to the dispensing unit.
Insert the milk pipework into the milk
valve on the left and right-hand sides.
Check that the milk pipework is snug
against the housing and that the
cover can be easily attached.
Tip: If necessary, screw the milk
pipework backwards at the connecting
piece on the right-hand side.
Attach the milk valve cover as
follows: insert the pin in the top right-
hand corner and swivel the cover
backwards until a proper fit is
achieved.
Push the left-hand bean container
and maintenance container back into
the coffee machine. Attach the
central spout's stainless steel cover.
Close the machine door.
To Next Page
Loading...
