Miele CVA 7840 - Installation; Electrical Connection

Installation
-
I
N
S
T
A
L
L
A
T
I
O
N
-
103
Electrical connection
Before connecting the coffee machine,
make sure that the connection data on
the data plate (voltage and frequency)
matches that of the electricity supply.
This data must correspond in order to
avoid the risk of damage to the coffee
machine. If in any doubt, consult a
qualified electrician.
The voltage and frequency are given on
the data plate located inside the
machine. Please ensure these match
the household mains supply. This data
must correspond in order to avoid
damage to the machine. The correct
fuse rating must also be observed.
This machine is supplied with a cable
and moulded plug (13A in the UK) for
connection to the mains electrical
supply.
If possible, the socket should remain
easily accessible. If the socket is no
longer accessible after installation, an
additional means of disconnection must
be provided for all poles. Suitable
means of disconnection include
switches with an all-pole contact gap of
at least 3mm. These include circuit
breakers, fuses and contactors
(EN60335).
Do not connect the coffee machine to
an off-grid inverter. These devices are
used for autonomous power supply,
e.g. a solar power system. Power
surges could cause a safety shutdown.
This could damage the electronic
module.
The coffee machine must not be used
with “energy saving plugs”. These
reduce the amount of energy supplied
to the machine, causing it to overheat.