Miele CVA 7840 - Cup Rim Sensor Issues; Bean System Issues

Problem solving guide
89
Problem Cause and remedy
F233 The cup rim sensor is not inserted or is incorrectly
inserted.
If the central spout is moving upwards and the cup
rim sensor is bumped, e.g. with a cup, the cup rim
sensor loses its reference position.
 Confirm the message withOK.
 Refit the cup rim sensor.
Cup rim detection remains inactive and the central
spout stays in the top position until the coffee
machine is next switched on. Cup rim detection is
reinitialised during the next switch-on operation.
F355, F357–F362 The bean system must be set up again, e.g. coffee
beans have possibly got jammed.
 Open the machine door and remove both bean
containers from the coffee machine.
 Close the machine door.
The bean system is set up.
 Follow the instructions in the display.
F307 The milk valve is faulty.
 Remove and clean the milk valve (see “Cleaning
the milk valve” in the “Problem solving guide”
chapter).