Cleaning and care
62
Connect together the angular molded
hose and longer milk pipework. Start
by attaching the top of the molded
hose to the main dispenser. The
black connecting piece should be
pointing to the rear.
Then, connect the bottom end of the
molded hose to the dispensing unit.
Insert the milk pipework into the milk
valve on the left and right-hand sides.
Push the connecting pieces into the
silicone seal as far as they will go.
Check that the milk pipework is snug
against the housing and that the
cover can be easily attached.
Tip: If necessary, screw the milk
pipework backward at the connecting
piece on the right-hand side.
Attach the milk-valve cover as
follows: insert the pin in the top right-
hand corner and swivel the cover
backward until a proper fit is
achieved.
Push the left-hand bean container
and maintenance container back into
the coffee machine. Attach the main
dispenser’s stainless-steel cover.
Close the appliance door.
To Next Page
Loading...
Need help?
General
