Cleaning and care
61
Press the retainers on the left and
right-hand sides of the milk-valve
holder and pull the holder forward to
remove it.
Take the holder and silicone seal
apart.
Pull the stainless-steel bolt upward
and out.
Clean the individual components of
the milk valve in the dishwasher.
Tip: If there are any dry milk residues
on the front, soak the stainless-steel
bolt in warm water and a little liquid
dish soap.
Installing the milk valve
Insert the stainless-steel bolt from
above.
Insert the silicone seal into the milk-
valve holder.
Insert the holder and silicone seal
until they audibly click into place.
To Next Page
Loading...
Need help?
General
