Installation
*
I
N
S
T
A
L
L
A
T
I
O
N
*
33
Secure the spacer strip underneath
the housing unit sides, flush with the
wall.
Draw a vertical line up both inside
walls of the housing from the front of
the spacer strip.
The brackets are designed for 16 and
19mm thick unit sides. Orientate the
bracket so that the vertical depth
matches the thickness of the unit
side.
Screw the brackets onto the right and
left inside walls of the housing unit as
shown. The back edge of the bracket
should align with the vertical line
drawn up from the front of the spacer
strip and the lower edge should align
with the lower edge of the housing
unit side wall.
To Next Page
Loading...
