Problem solving guide
38
Many malfunctions and faults that can occur in daily operation can be easily
remedied. Time and money will be saved because a service call will not be
needed.
The following guide may help you to find the reason for a malfunction or a fault,
and to correct it.
Problem Cause and remedy
The deflector place is
not opening or closing
correctly, e.g. after a
power failure.
There is a fault with the controls.
Remove the grease filter.
Press “”, “”, “” and “” in succession on the
control panel.
The deflector plate will open and close once or several
times.
To Next Page
Loading...
