Miele ESW 7010 - Connecting via WPS

Before using for the first time
19
Connecting via WPS
Your Wi-Fi router must support WPS
(Wi-Fi Protected Setup).
 Switch the drawer off.
 Press and hold the sensor.
 At the same time, touch the
sensor.
2h will light up constantly, 3h will flash
on and off.
The WPS connection must be started
on the drawer at the same time as on
the Wi-Fi router.
 Touch the sensor control on the
drawer after a few seconds.
After a short while, 2h will light up
constantly, and 3h and 4h will flash on
and off.
The drawer will be ready for connection
in the next 10minutes.
 Start the WPS connection on your
Wi-Fi router.
When successfully connected, 2h and
3h will light up constantly.
 Quit the connection mode on the
drawer by touching the sensor.
The drawer can now be operated via
the App.
If the connection fails, you have
probably not connected WPS on your
router quickly enough. Repeat the steps
above.
Useful tip: If your Wi-Fi router does not
support WPS, please connect via the
Miele@mobile App.
Signing out of Wi-Fi (resetting factory
default settings)
To set up a new Wi-Fi connection, the
existing Wi-Fi connection must first be
disconnected.
 Switch the drawer off.
 Press and hold the sensor.
 At the same time, touch the
sensor.
With an existing Wi-Fi connection, 2h
and 3h will light up constantly.
The drawer will be ready for
disconnection in the next 10minutes.
 Touch the  sensor.
2h will light up constantly, 3h will flash
on and off.
After a few seconds, 2h and 3h will
flash on and off. The connection has
been disconnected.
 Quit the signing-off mode on the
drawer by touching the sensor.
The Wi-Fi connection has been
disconnected. A new connection can
now be set up.