Operation
20
Operating principles
Malfunction due to dirty and/or
covered sensor controls.
The sensor controls do not react or
unintentional switching procedures
result, perhaps even automatic
switching off of the drawer.
Keep the sensor controls and
indicators clean.
Do not place anything over the
sensor controls or indicators.
Damage caused by leaking
liquids.
Liquids that get inside the drawer
can cause a short circuit.
Open and close the loaded drawer
carefully to prevent liquids from
spilling.
Open the drawer.
Switch the drawer on by touching the
sensor.
Touch the sensor repeatedly until
the required function lights up.
Touch thesensor repeatedly until
the segment for the required
temperature lights up in the
temperature display.
Touch the sensor repeatedly until
the required operating duration (in
hours) lights up.
Close the drawer.
To Next Page
