Aligning the appliance
^
Align the appliance with the custom
front.
The installation aids e on the
appliance door have been designed for
custom door thicknesses of 3/4"
(19 mm) and 1 1/2" (38 mm).
The height-adjustable feet at the front
and rear can all be adjusted from the
front:
–
Front feet:
Adjust with a rachet 5/16" (8 mm) f
–
Rear feet:
Adjust with a (cordless) screwdriver
and/or a rachet 5/16" (8 mm) for fine
adjustment g
^
Use a level to align the installation
aids e on the door.
Important!
When unscrewing the
height-adjustable feet, proceed
gradually, alternating between left
and right.
–
Unscrew the height-adjustable feet
until the mark on the base has
reached the indicated guide
dimension 1 1/4" (32 mm). The guide
dimension of 1 1/4" (32 mm) is
related to a niche height of 84"
(2134 mm).
^
Align the appliance again using a
level.
Note:
–
When unscrewing the
height-adjustable feet, proceed
gradually, alternating between left
and right.
–
If using a wooden beam as an
alternative anti-tip device, rotate the
appliance all the way toward the
wooden beam.
Installing the appliance
63
To Next Page
Loading...
