T o p ro g ram m e th e w ater h ard ness
lev el
E ach time a button is pressed, one of
the indicator lights will flash and light
up in the control panel. H owever, only
the indicator lights mentioned in the
following programming process stages
are significant.
The programming procedure can be
cancelled at any time by pressing the
O ff button V. The procedure can
then be re-started from the beginning
again.
^ S witch the dishwasher off using the
O ff button V.
^ P ress the programme selector button
in, and w h ilst h o ld ing it in switch
the dishwasher on using the O n
button U.
K eep the programme selector button
pressed in for at least four seconds
until the lower right hand programme
indicator comes on.
If this does not happen, start the
procedure from the beginning again.
^
P ress the Turbo/Tab button twice.
The Tab indicator light will flash briefly
twice at intervals.
The characters "p 1" will flash one after
the other in the display .
This means that the water hardness
level has been set at 1 ° d (0.2 mmol/l)
(factory setting).
The value which has been set for the
water hardness is shown as a figure
after the "p" in the display (see the
following chart).
U se the programme selector button to
select the value which corresponds to
y our water hardness level.
E ach press on the button moves y ou up
a level. W hen the highest water
hardness level is reached, the setting
starts from the beginning again.
^ S witch the dishwasher off with the O ff
button V.
B efo re u sing fo r th e first tim e
16
To Next Page
Loading...
Need help?
General
