Technical Information
5
G 1xxx/G 2xxx
4.13 Removing the Circulation Pump ........................................................... 106
4.14 Removing the Circulation Pump Housing Cap (with Ring Heater) ........ 107
4.15 Slide Shutter Removal (Excella/LaPerla) .............................................. 108
4.16 Drive Removal (Excella/LaPerla) .......................................................... 108
4.17 Pump Impeller Removal ....................................................................... 109
4.18 Pump Housing Removal ....................................................................... 109
4.19 Pump Capacitor Removal ..................................................................... 110
4.20 Removing the Heater Pressure Switch ................................................. 110
4.21 Speed Sensor Removal (MPEW Pumps Only) ..................................... 110
4.22 Removing the Drain Pump ................................................................... 110
4.23 Removing the Sump ............................................................................. 111
4.24 Removing the NTC Temperature Sensor ............................................. 112
4.25 Removing the Float .............................................................................. 112
4.26 Removing the Float Switch ................................................................... 112
4.27 Dismantling the Filter Combination ....................................................... 113
4.28 Filter Combination Assembly (New Microfine Filter and Handle) .......... 114
4.29 Filter Combination Assembly (with Locking Piece) ............................... 115
4.30 Salt Container (in Sump) Removal ....................................................... 117
4.31 Filling the Salt Container in the Sump .................................................. 118
4.32 Salt Container in Door (SIT) Removal .................................................. 119
4.33 Brine Valve (Y60) Removal .................................................................. 120
4.34 Filling the Salt Container in the Door .................................................... 120
4.35 Water Level Check ............................................................................... 122
080 Electronic .............................................................................................................. 123
2 Function ............................................................................................................ 124
2.1 General Operation ................................................................................ 124
2.1.1 Novotronic Controls ........................................................................ 124
2.1.2 Touchtronic/Navitronic Controls ...................................................... 124
2.1.3 Incognito Controls ........................................................................... 125
2.2 Component Test ................................................................................... 125
2.2.1 Test Sequence and Background Information ................................. 126
2.3 Machine Response Following a Power Failure ..................................... 128
2.4 Turbo Function (Select Models) ........................................................... 128
2.5 “Dishes Can Be Added” Function (LaPerla II) ...................................... 129
2.6 SensorDry Feature (Select Models) ..................................................... 129
2.7 Drying Plus Function (LaPerla II) .......................................................... 130
2.8 Dealer Demo Mode (Excella/LaPerla) .................................................. 132
2.9 Electronics ID Summary ....................................................................... 132
2.10 Programming of Language and Time of Day at First Commissioning
(Excella/LaPerla) .................................................................................. 134
3 Fault Repair ...................................................................................................... 134
3.1 Main Switch Is On, No Message in Display .......................................... 134
3.2 Rinse Aid Used Up Too Quickly (Models with SensorDry) ................... 134
3.3 Program Can Be Selected but Not Started ........................................... 134
3.4 Program Interrupted, No Fault Indication .............................................. 135
3.5 Diagnostic Support Cannot Establish a Connection ............................. 135
3.6 Settings Selected During Initial Commissioning Are Not Saved ........... 136
3.7 Tea Residues in “Sensor Wash” Program (ID No. -876) ...................... 136
3.8 Fault Code Summary ............................................................................ 137
To Next Page
Loading...
Need help?
General
