Turbo
The "Turbo" function can be used to
reduce the program run-times, in
programs in which the option is
available.
^ Turn the dishwasher on "K".
The "Start / Stop" indicator flashes.
^ Press the "Turbo" button.
The "Turbo" indicator lights up.
The option will remain active for all
programs until the setting is changed
again.
^ A program can now be started as
usual or the dishwasher can be
turned off "K".
Default settings
All settings can be reset to the factory
default.
^ Turn the dishwasher off "K".
^ Press and hold the "Start / Stop"
button and at the same time turn
the dishwasher on "K". Hold the
"Start / Stop" button until the indicator
lights up.
If it does not come on, start over.
^ Press the "Delay Start" button 12
times.
The "Rinse & Hold" indicator gives one
long flash and two short flashes in
intervals.
The "Rinse" indicator lights up showing
that a setting other than the factory
default has been set.
– If the "Rinse" indicator light is
flashing:
All settings are factory default.
– If the "Rinse" indicator is not lit up:
At least one setting has been altered
from the factory defaults
^ To reset the dishwasher to the factory
default settings, press the "Start /
Stop" button.
The setting is saved.
^ Turn the dishwasher off "K".
Additional options
31
To Next Page
