General problems with the dishwasher
Issue Possible fault Solution
The display turns off. The dishwasher has
gone into "Standby"
mode to save energy.
Press any button.
The display turns on again.
Detergent is left in the
dispenser at the end of
a program.
The dispenser was damp
when detergent was
added.
Dry the dispenser before
adding detergent.
The detergent lid
cannot be closed
properly.
Detergent residue is
blocking the catch.
Remove the residue.
The door and the
interior walls are still
wet after a program has
finished.
This is not a fault!
It is the normal operating
mode of the drying
system.
The moisture will evaporate
after a short time.
Water remains in the
wash cabinet at the end
of a program.
Before fixing the fault:
– Turn the dishwasher off
"s".
The triple filter in the
wash cabinet is clogged.
Clean the triple filter. See
"User Maintenance
Instructions".
The drain pump or the
non-return valve may be
blocked.
Clean the drain pump and
the non-return valve, see
"User maintenance
instructions".
The drain hose is kinked. Remove any kinks from the
drain hose.
Frequently asked questions
35
To Next Page
Loading...
