With the aid of the following guide, minor problems can be fixed without a service
call.
,
Repairs should only be carried out by a qualified and trained person in
accordance with local and national safety regulations. Unauthorized repairs
could cause personal injury or machine damage.
Technical faults
Issue Possible fault Solution
The Start / Stop
indicator does not flash
after the dishwasher is
turned on with "s".
The machine is not
plugged in.
Insert the plug.
The fuse has tripped. Reset the circuit breaker.
See data plate for
minimum amperage.
The dishwasher stops
during a program.
The fuse has tripped. Reset the circuit breaker.
See data plate for
minimum amperage.
The program cycle
indicators "Rinse",
"Drying" and "End"
flash at the same time.
There may be a technical
fault.
– Turn the dishwasher off
"s".
After a few seconds:
– Turn the dishwasher on
"s".
– Select the desired
program with the
"Program" button.
– Press the "Start / Stop"
button.
If the problem persists,
contact Technical
Service.
The drain pump is
running when the door
is open.
The waterproof system
has activated.
– Turn off the water
supply.
– Contact Miele
Technical Service.
Frequently asked questions
33
To Next Page
Loading...
