Miele G 2472 - Inspira and Diamante Series Programming (G 2120;G 2140;G 2150)

Technical Information
26
G 1xxx/G 2xxx
Water Hardness [°d] Water Hardness [gpg]
Flash Pattern of "Rinse"
LED
1 – 4 1.1 – 4.3 1x rapidly
5 – 7 5.4 – 7.5 2x rapidly
8 – 11 8.6 – 11.8 3x rapidly
12 – 15 12.8 – 16.1 4x rapidly
1
16 – 20 17.1 – 21.4 5x rapidly
21 – 25 22.5 – 26.8 6x rapidly
26 – 30 27.8 – 32.1 7x rapidly
31 – 36 33.2 – 38.5 8x rapidly
37 – 50 39.6 – 53.5 9x rapidly
51 – 70 54.6 – 74.9 1x slowly
Table 16: Water Hardness Settings, G 2020
1
Standard setting.
Rinse Aid Volume [mL]
1
Flash Pattern of "Rinse" LED
0 —
1 1x rapidly
2 2x rapidly
3 3x rapidly
2
4 4x rapidly
5 5x rapidly
6 6x rapidly
Table 17: Rinse Aid Quantities, G 2020
1
One milliliter equals 0.3 fluid ounces.
2
Standard setting.
2.7 Inspira and Diamante - G 2120/G 2140/G 2150
Initial requirements:
1. Close the door.
2. Switch off the appliance.
Accessing:
1. Press and hold the Start/Stop button.
2. Switch on the appliance.
3. Release the Start/Stop button.
4. Immediately press the Start/Stop button 5 times; on the 5
th
time, hold
until the "Start/Stop" LED flashes.
5. Release the Start/Stop button.
6. If the "Start/Stop" LED does not light up, repeat the procedure.
Acknowledgement indicator:
The "Start/Stop" LED flashes rapidly (5 flashes per second).